Skip to content
MVP Interiors - Coulee Region flooring
Squeaky Floors: What Causes Them and How They Get Fixed
Guides · October 19, 2026 · 6 min read

Squeaky Floors: What Causes Them and How They Get Fixed

A squeak is almost always two pieces of a floor moving against each other. Finding which two pieces, and stopping them moving, is the whole repair.

A squeaky floor is rarely a sign that anything is about to fail. It is a sign that something is moving that should not be. Every squeak is two surfaces rubbing: a subfloor sliding up and down a nail, a board rubbing against its neighbor, a floor flexing over a gap underneath it. The repair is about finding which of those it is and stopping the movement, not about covering the noise.

The cause decides the fix, and the floor on top decides how easy the fix is to reach.

Where squeaks come from

  • Subfloor that has lifted off a joist. When the plywood or boards under the floor are no longer tight to the framing, each step pushes them down and they rub on the nails holding them. This is the most common cause in houses of any age.
  • Nails that have loosened. Framing lumber dries and shrinks over the years, and nails lose their grip. A nail shank sliding in its hole is a classic squeak.
  • Gaps between a joist and the subfloor. Where a joist sits slightly low or has twisted, there is a small void under the subfloor, and the floor flexes into it.
  • Wood floorboards rubbing against each other. Tongue-and-groove hardwood can squeak at the joints, especially through a dry winter, when boards shrink and loosen slightly.
  • Stairs. Treads rubbing on risers, stringers or nails are the same problem in a smaller space, and stairs take more force per step than a flat floor.

A floor that bounces or sags noticeably is a different issue. That points to the framing itself, such as undersized or damaged joists, and it is structural work for a framing contractor or engineer to assess rather than a squeak to be screwed down.

Squeaks that come and go with the seasons

In a heated Wisconsin house, indoor air gets very dry through the winter, and wood gives up moisture and shrinks. Joints that are tight in August can loosen enough in January to start talking, then go quiet again as the humidity rises in summer. A humidifier through the heating season reduces that movement. A squeak that is present all year round is more likely a fastening problem than a seasonal one.

The same dry air is what opens thin gaps between hardwood boards in winter. Cleaning hardwood floors without damaging them covers seasonal gaps and why they should not be filled.

Fixing a squeak from below

Where the underside of the floor is reachable, from an unfinished basement or crawlspace, that is usually the cleanest route, because nothing on the finished floor gets touched.

  • Find the spot. One person walks the floor above while another listens and watches the subfloor below for movement.
  • Close the gap. Where there is a void between joist and subfloor, a thin wood shim with construction adhesive is tapped in snugly. The aim is to fill the gap, not to drive the floor upwards, which can create a hump or a new squeak nearby.
  • Add support. Where a longer section of subfloor is loose, a length of lumber glued and fastened alongside the joist, tight under the subfloor, supports it along its length.
  • Screw rather than nail. Screws hold where nails have worked loose. Screw length matters, because a screw that comes through the top of the finished floor is a new problem.

Fixing a squeak from above

Where the ceiling below is finished, or there is no way to get underneath, the repair has to come from the top, and the floor covering decides how.

  • Carpet. Special screw kits drive a screw through the carpet and pad into the joist, then snap the head off below the surface so the carpet closes back over it. Done carefully, there is nothing to see afterwards.
  • Nail-down hardwood. A pilot hole is drilled through the board into the joist, a screw is countersunk below the surface, and the hole is filled with wood filler or a plug matched to the floor. On a well-matched floor it is hard to find.
  • Board-to-board squeaks in hardwood. Where the noise is the boards themselves rather than the subfloor, a dry lubricant worked into the joint can quiet it temporarily. It does not fix a loose subfloor, and it is not a substitute for refastening.

Floating floors that click or sound hollow

Click-lock LVP and laminate are not fastened down, so they cannot be screwed to stop a noise. When a floating floor clicks, crackles or sounds hollow in one area, the usual cause is a subfloor that is out of flat under that spot. The floor flexes over the low point at every step, and the locking joints rub as it does. Over time that flexing can also separate the joints.

The fix is underneath: the floor is unclicked back to the problem area, the low spot is leveled or the high spot taken down, and the planks go back. Near a wall, that is manageable. In the middle of a large room, it means lifting a good part of the floor, which is why getting the subfloor flat before installation matters so much.

Taking planks up without damaging them is covered in damaged floor planks: repair one board or redo the room?

The best time to fix a squeak

The cheapest moment to fix a squeak is when the old floor is out and the subfloor is bare. Every loose area can be found by walking it, refastened with screws into the framing and checked again, with no finished surface to protect and nothing to patch afterwards. A squeak covered by a new floor does not stop squeaking, and once the new floor is down the easy fix has gone.

Stairs are the same. When carpet comes off a staircase, the treads and risers are open, and squeaks can be fastened and glued before anything new covers them.

That is why we walk the subfloor and refasten it as part of preparation on every flooring job. Subfloor prep: the part of the job you never see covers the rest of what happens at that stage, and carpeted stairs to hardwood covers stairs.

Getting a squeak looked at

If you are planning new hardwood, luxury vinyl plank, laminate or carpet, tell us where the floor squeaks when we measure, and we will plan to fix it while the subfloor is open. Every installation carries our lifetime workmanship warranty. Book a free in-home estimate and walk us over the spots that talk.

Published October 19, 2026 by MVP Interiors · Onalaska, WI · (608) 304-3038
Common questions

Your questions, answered

Why does my floor squeak?

+

Because two parts of it are moving against each other. The most common causes are subfloor that has lifted off a joist, nails that have loosened as the framing dried, small gaps between a joist and the subfloor, and wood boards rubbing at their joints. The cause decides the fix.

Why do my floors squeak more in winter?

+

Dry heated air. Wood gives up moisture and shrinks in winter, which loosens joints and fasteners slightly. Squeaks that appear in the heating season and fade in summer are often seasonal, and a humidifier helps. A squeak that lasts all year is more likely a fastening problem.

Can squeaky floors be fixed without removing the floor?

+

Usually. From an unfinished basement, gaps are shimmed and the subfloor is screwed or supported from below. From above, carpet squeaks are fixed with screw kits that disappear under the pile, and hardwood is screwed through a countersunk pilot hole that is then filled or plugged.

Why does my LVP or laminate floor click when I walk on it?

+

Usually because the subfloor is not flat under that spot. A floating floor flexes over a low area with every step and the joints rub. It cannot be screwed down, so the fix is lifting the planks back to the area, leveling the subfloor and reinstalling.

Should squeaks be fixed before new flooring is installed?

+

Yes. With the old floor out, the subfloor can be walked, refastened into the framing and checked with nothing to patch afterwards. A new floor laid over a squeaky subfloor will squeak too, and fixing it later is harder.

Is a squeaky floor a structural problem?

+

Usually not. Most squeaks are loose fastening rather than failing framing. A floor that bounces, sags or slopes noticeably is different, and that should be assessed by a framing contractor or engineer.

Hardwood Flooring in towns we serve

Financing

12-month same-as-cash and 84-month fixed-rate plans available.

Most decisions return in minutes. We work with GreenSky and Synchrony so you can lock the project, then choose terms that fit your budget.

More from the blog
Get started

Ready to turn a guide into a real quote?

Free in-home flooring estimate anywhere in the Coulee Region - samples, a measured drawing, and a fixed price with no high-pressure pitch.

Email Free Estimate